Cisco 642-176 Questions,Money Back Guarantee Cisco 642-176 Testing Are Based On The Real Exam

ATTENTION: Get your Cisco 642-176 certification easily with,Flydumps latest Cisco 642-176 exam dumps. All the up-to-date questions and answers were added to the new version.Go to the site Flydumps.com to get more Cisco 642-176 exam
information.

QUESTION 35
Your Customer has 21 users, each requiring both PC and IP Phone connectivity. Which is the correct configuration for this customer?
A. 1 Cisco 2811 ISR, 1 Catalyst Express 500G-12TC, 2 Catalyst Express 500-24PC
B. 1 Cisco 2851 ISR, Catalyst Express 500G-12TC, 3 catalyst Express 500-24PC
C. 1 Cisco 2821 ISR, Catalyst Express 500G-12TC, 2 Catalyst Express 500-24PC
D. 1 Cisco 2801 ISR, 1 Catalyst Express 500-24PC

Correct Answer: D Section: (none) Explanation
Explanation/Reference: QUESTION 36
When using Cisco Network Assistant to configure a WS-CE500-24LC switch, which three are available choices in the port settings window? (Choose three.)
A. Duplex mode selections
B. Auto MDIX selections
C. Status Selections
D. Group mode selections
E. Port security selections

Correct Answer: ABC Section: (none) Explanation
Explanation/Reference:
QUESTION 37
Which statements describes the remote sites in a Cisco Single-Site Secure Network Foundation solution with remote teleworkers?
A. They are separate from the central site and use NAT to route through the Internet to the Central Site
B. They are part of the VLANs at the Central Site; they are in the same subnets
C. They use public IP Addresses that are routable through the Internet
D. They are in separate subnets but are part of the private address space of the network

Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 38
Which two statements about 802.1Q trunking in Secure Network Foundation Design Guide for Single Site Deployments are correct?
A. The Cisco Control VLAN carries only Layer 2 control traffic
B. 802.1Q trunking is used between the access switch and the router
C. There is no 802.1Q trunking used in these designs
D. When 802.1Q trunks are configured, they are also called Native VLANs
E. Trunking Ensures that traffic from only one VLAN is carried on that trunk

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 39
Exhibit: You work as a network technician at Certkiller .com. Please study the exhibit carefully. Which Cisco SDM configuration task would you select to configure a static route to the Service Provider?

A. NAC
B. Routing
C. Intrusion Protection
D. Quality Of Service
E. NAT

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 40
Which WAN connection requires a different interface than the standard interface provided in the Cisco Single-Site Secure Network Foundation deployment design?
A. Metro Ethernet
B. DSL
C. VPN
D. Cable
E. Frame-Relay

Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 41
What is the reason for running spanning-tree in a Cisco Single-Site Secure Network Foundation Solution?
A. To protect the network in case someone inadvertently creates a physical loop in it
B. To ensure that if a device fails another device automatically take over for it
C. To allow management of all network devices
D. To aggregate logical network groups together at one central point

Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 42
Which two statements about configuration an unconnected Catalyst Express 500 switch from setup mode using a PC are true? (Choose two.)
A. You may use Cisco Network Assistant to set up the initial configuration
B. You must use CLI for initial configuration
C. You may use either CLI or CAN for configuration
D. You may make a direct connection to the PC from any point on the switch
E. You may only make a direct connection from the port with the flashing green LED to the PC

Correct Answer: AE Section: (none) Explanation
Explanation/Reference:
QUESTION 43
When using Cisco Network Assistant to configure smartports, Which tow of the following roles can belong to a VLAN of the type “access” ? (Choose two.)
A. Phone + Desktop
B. Desktop
C. Switch
D. Router
E. Trunk

Correct Answer: AB Section: (none) Explanation
Explanation/Reference:
QUESTION 44
Exhibit: You work as a network technician at Certkiller .com. Please study the exhibit carefully. In a Cisco Single-Site Secure Network Foundation implementation, which factor affects your choice of switch Configuration?

A. Type of Security scheme that is being implemented
B. Maximum number of supported IP Phones
C. Maximum Amount of packet latency acceptable
D. Type of QoS scheme that is being used

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 45
You are designing a solution that needs to support 40 IP phone users. Which routers model does the Cisco Single-Site Secure Network Foundation 1.1 Designing and Implementation Guide suggest for this Solution?
A. Cisco 3825
B. Cisco 2851
C. Cisco 3845
D. Cisco 2811
E. Cisco 2821
F. Cisco 2801

Correct Answer: E Section: (none) Explanation
Explanation/Reference:
QUESTION 46
Exhibit:

You work as a network technician at Certkiller .com. Please study the exhibit carefully. Which two interfaces are enabled for 802.1Q encapsulation? (Choose two.)
A. Router Certkiller 2, Gig 0/1
B. Switch Certkiller B, Fast Port 1 to 24
C. Sswitch Certkiller A, Gig Port 9
D. Router Certkiller 2, Gig 0/0

Correct Answer: AC Section: (none) Explanation
Explanation/Reference:
QUESTION 47
Which three of these are characteristics of UTP cable? (Choose three.)
A. The wires in each pair are wrapped around each other
B. An insulating material covers each of the individual copper wires in it
C. It comes in eight-pair wire bindles
D. EMI and RFI cause only limited degradation to signals running over it
E. It comes in seven categories
F. IT has an external diameter of approximately 0 28 inches

Correct Answer: ABD Section: (none) Explanation
Explanation/Reference:
QUESTION 48
Exhibit:

You work as a network technician at Certkiller .com. Please study the exhibit carefully. From this Cisco SDM security Audit Wizard screen, what should you do to secure the Router?
A. Click Next
B. Click Fix All, then Next
C. Click Fix All, then clear CDP check box, then Next, then manually disable CDP on the WAN interface
D. Click Fix All, the clear CDP check box, the Next
E. Click Fix All, then Clear CDP check box, then Next, then Immediately reboot the router

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 49
Which two statements correctly identify factors to consider when Configuring WAN QoS ? (Choose two)
A. Voice Traffic uses Assured Forwarding
B. Voice Signaling traffic uses Assured Forwarding
C. Voice Signaling traffic uses priority queuing
D. Voice Traffic uses priority queuing
E. Voice signaling traffic should use priority queuing with Assured Forwarding

Correct Answer: BD Section: (none) Explanation
Explanation/Reference:

Cisco 642-176 Questions & Answers with explanations is all what you surely want to have before taking Cisco 642-176.Cisco 642-176 Interactive Testing Engine is ready to help you to get your Cisco 642-176 by saving your time by preparing you quickly for the Cisco exam. If you are worried about getting your Cisco 642-176 certification passed and are in search of some best and useful material,Cisco 642-176 Q&A will surely serve you to enhance your Interconnecting Cisco Networking Devices Part 1 stydy.